Populära länkar
Kategorier
Fördelar med oss
- Inga avgifter
- Gratis frakt över 899:-
- Snabb leverans
- KUNDSERVICE med riktiga jägare
- Öppet köp returrätt 30 dagar
- Betala säkert med avgiftsfri faktura, kort eller internetbank
- På nätet sedan
2005
- Tel 060 - 124 000, vardagar 9-12, 13-17
- Maila oss
PMA Micro Die Adjuster
Köp & prenumerera
För automatisk leverans av den här produkten välj intervall nedan och tryck på "KÖP"-knappen. Du får varan levererad omgående och sedan samma datum varje period tills du väljer att avsluta prenumerationen. Läs mer om prenumerationer.
- Beskrivning
- Berra Tycker
PMA MICRO DIE ADJUSTER W/SET SCREW
For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been pleased with them. It seems we always misplace them, or can't find the ones we need, or grab the wrong ones, and they always seem to be covered in rust. For as many years as we've been doing this we've always been looking for a better way. After searching off and on for a solution to this nagging problem we finally have a workable solution. The PMA Micro Die Adjuster.
The PMA Tool Micro Die Adjuster (MDA) replaces your existing lock ring and can be used with nearly any 7/8-14 full length sizing die. We successfully used this tool with sizing dies from Redding, RCBS, Hornady, Lee, Harrells Precision and those made from Newlon Precision die blanks. It allows you to easily make adjustments to your “shoulder bump” as fine as .0005”. The engraved marks on the MDA are equal to approximately .001” (true adjustment .000992”) of adjustment to the shoulder bump. Splitting the engraved marks is therefore approximately equal to .0005”. The design of the MDA does not allow it to work with the Forster Co-Ax press and is not intended for use with turret presses, progressive presses or the RCBS Summit press. Some custom dies for very short cartridges may require the use of an extended shellholder.Micro Die Adjuster shown in use installed on Custom Newlon 6mm Grendel Die and RCBS TM RockChucker press.
*Includes Set Screw for locking the adjustment in place
Optimal pryl för att göra det lätt att styra och ställa headspace vid kalibrering av hylsor. Reddings shellholder set anser jag har för stora steg och gör att det inte blir så optimalt som man kanske önskar. Denna löser det med råge och här går det att ställa helt perfekt tills man är nöjd.
- Berra Tycker
Optimal pryl för att göra det lätt att styra och ställa headspace vid kalibrering av hylsor. Reddings shellholder set anser jag har för stora steg och gör att det inte blir så optimalt som man kanske önskar. Denna löser det med råge och här går det att ställa helt perfekt tills man är nöjd.
- Fakta om produkten
- Prishistorik